Este informe detalla el proceso de diseño e implementación de un sistema anfitrión desarrollado para albergar el núcleo de simulación. Este sistema hizo posible descargar el NSN en un chip FPGA, con el fin de poder verificarlo ...

Mismanagement of land dedicated to agricultural activities, coupled with adverse weather conditions, generate erosion that wears the soil and pollute the surrounding water bodies. One of the methods used to quantify erosion ...

Costa Rica is a country with many natural resources, where the economic development is linked to the agricultural production. Therefore, the loss of nutrients and problems related to erosion has a high impact. Some of the ...

Cross correlation is a way of measuring how similar two signals are. However, traditional methods of implementing this algorithm require a lot of resources which promotes a constant search of alternative ways of performing ...

This thesis describes the development of simulation models of FFE stages (Feed Forward Equalizer) in transmitters for high-speed channel analysis. The implementation of this equalizer was performed using two different ...

In the recent years UAV´s have become very popular. Due to the acquire fame of these devices, a wide number of applications have been developed in order to satisfy a demanding market that seeks new ways to improve the ...

Costa Rica has a fourth of its national territory that corresponds to protected forest areas, which area constantly foraged by poachers and illegal loggers. Determining where and whendoes an illegal act happen is a hard ...

This thesis is the result of an investigation research on alternatives to develop a computerized vision system to measure the position of colored pellets on a planar noncontact magnetic manipulation platform (MagMan). This ...

A methodology that measures the DSP performance of a ASP with low-power target applications is presented. Additionally, the timing, area and power synthesis results for an adder, a multiplier and a CORDIC oating point ...

Actualmente, en el curso Laboratorio de Control Automático de la Escuela Ingeniería en Electrónica, el estudiante debe realizar dos proyectos cortos en donde se les enseña a caracterizar la planta en estudio y a diseñar ...