Development of a measuring program for single parts of an electronic stability control using a coordinate measuring machine
Resumen
The project was carried out in the Quality Control Department of Continental AG located in Frankfurt am Main, Germany. Continental developed a braking system called MK 100®, which makes it possible to install ABS/ESC in all vehicle categories. In the manufacturing process, there are many factors that can affect the dimensions of the geometric features of the product, so it is necessary to establish a method for identifying that these features lay within the defined tolerance values.
The main goal of the project is to develop a measuring program for the valve block of the electronic stability control module. The measuring program is developed using a coordinate measuring machine that measures all the specified geometric features defined in the technical drawing of the workpiece. At the end, the software generates a report that shows all the measured and calculated geometric features and they are compared with the nominal values. Each of the features has a range of accepted values and the report indicates if the values are in the tolerance zone or out of it.
This document describes all the important concepts regarding coordinate metrology that is necessary for developing the measurement protocol and understanding the results of the measurement report. It also contains a description of all the important steps when developing a measurement strategy and the way the coordinate measuring machine Leitz PMM 866 is programmed using the Quindos 7 software.
Descripción
Proyecto de Graduación (Licenciatura en Ingeniería Mecatrónica) Instituto Tecnológico de Costa Rica, Área Académica de Ingeniería Mecatrónica, 2016.
Compartir
Métricas
Colecciones
Ítems relacionados
Mostrando ítems relacionados por Título, autor o palabras clave.
-
Diseño de una planta demostrativa para el entrenamiento de TSR sobre Instruments Control en NI
Arias-Madrigal, Steven (Instituto Tecnológico de Costa Rica, 2024-06-11)Este informe pretende mostrar el diseño de una planta de entrenamiento para capacitar a los Technical Support Representative (TSR) en el tema de Instruments Control con sistemas de National Instruments (NI), para esto ... -
Diseño de un manual de selección de materiales de construcción de instrumentos de medición de flujo, presión y temperatura que ofrece la empresa Emerson Electric Costa Rica Limitada de acuerdo con las características y requerimientos de los ambientes en los que se desempeñan
Chavarría-Ledezma, Abril Irán (Instituto Tecnológico de Costa Rica, 2023-11)Este proyecto fue desarrollado para la empresa Emerson Electric Costa Rica Limitada, localizada en San Rafael de Escazú y consiste en el diseño de un manual de selección de materiales de construcción de instrumentos ...